* All product’s images are illustrative.

DAA Output Chute and Spring

The DAA Output Chute can be attached to any reloading press, hanging onto the same bracket which usually holds the Akro-Bin, and replacing it.


22.20 €


The DAA Output Chute can be attached to any reloading press, hanging onto the same bracket which usually holds the Akro-Bin, and replacing it.

The long, 120cm (4ft) feed spring enables you to run the ammo down to a container on the floor, sparing you the need to empty that bin as you reload, and uncluttering your reloading press.

This Output Chute is also designed to clip on below the output ramp of the DAA Automatic Brass Marker, and can be used there to output the ammo down to a container on the floor or below your workbench.

This Chute has been tested to work perfectly with all pistol caliber ammo (9-40), although some types of 0.45 bullets have been seen to hang up occasionally. It works well with .223 rifle ammo too. It is designed to handled loaded ammo, not brass, which is more likely to hang-up.

You might also like