PDR PRO-II Belt Ride Ambidextrous Hanger Kit

Upgrade Your Holster with the PDR PRO-II Ambidextrous Belt Ride Hanger Kit

The PDR-PRO-II Belt Ride Ambidextrous Hanger Kit includes everything you need to convert your DAA PDR PRO-II holster body into an IDPA-compatible holster. This hanger positions the holster body close against your body, providing a solid yet tilt-adjustable holster mount. It is compatible with 1.5-2” wide belts and is fully ambidextrous, working equally well for both right-handed and left-handed holsters.

To assemble the PDR-PRO-II Belt Ride Ambidextrous Hanger Kit to your PDR PRO-II holster, follow these steps:

• Remove your PDR PRO-II hanger by unlocking the screw in the ball joint and sliding it down off the rail.
• Remove the rail and keep the small flat screws safely with the rail.
• Place two washers over each screw nut, then the hanger, and finally the short screws. Adjust the required tilt angle and tighten.
• If you are using the belt spacers (most will, as most use a 1.5” belt), you can choose to have those spacers both above, below, or one above and one below the belt as you thread it through. This will provide you with some height adjustment.
• If you need to remove a belt spacer, rotate it 90 degrees and then slide it out. A little force is required.
• If you plan to use your holster in an IDPA match, replace the tension adjustment thumb-screw with the Phillips-head screw included in this kit.

Please note: This PDR-PRO-II Belt Ride Ambidextrous Hanger Kit can only be used with PDR PRO-II holster bodies (not the older PDR PRO). The newer PDR PRO-II body is the one that has an aluminum rail running up its inner side, which is attached with only two mounting points, unlike the older plastic T-rail which had three mounting points.